40-Amp Pro Switch-Mode BEC Brushless ESC (V2)

Details:

E-flite 40-Amp Pro Switch-Mode BEC Brushless ESC (V2) is a high-quality sensorless brushless electronic speed control with an integrated switch-mode BEC that is very lightweight and efficient. It can operate without the need for a separate receiver battery to power your servos and receivers, saving you weight and complication.

Features:

Up to 40 amps continuous current with proper air flow and 55 amps burst current (15 seconds) 5A continuous current, 5V Switch-Mode BEC Circuit (Proper cooling and airflow required) Stronger BEC for support of most 3-axis stabilization systems Drive up to 7 analog or 6 digital standard-sized servos with the BEC 3- to 6-cell Li-Po, 9- to 18-cell Ni-MH/Ni-Cd input voltage Finned heat sinks Programmable motor braking Safe power-arm mode prevents accidental starts Programmable low voltage cutoff with settings for 3-cell Li-Po (9V), 4-cell Li-Po (12V), 5-cell Li-Po (15V), 6-cell Li-Po (18V) or 70% of battery starting voltage Programmable throttle input range Programmable soft start for helis and airplanes Auto motor shut down if signal is lost or there is interference Programmable timing.5 user-selectable ranges to use with a large variety of brushless motors Utilizes new smaller Mosfet technology to minimize weight Radio System Power ON /OFF Switch Prewired connectors. E-flite EC3€ž¢ connector on battery input and 3.5mm gold bullet connectors on motor output leads

Specifications:

Continuous Maximum Current: 40A (Proper cooling and airflow required) Input Voltage: 3œ6S Li-Po or 9œ18 Ni-MH/Ni-Cd Input Connector Types: 13 AWG with E-flite EC3 Connector Output Connector Types: 13 AWG with 3.5mm Gold Bullet Connectors Momentary Peak Current: 55A (15 sec) (Proper cooling and airflow required) Length: 68.0mm (2.70 in) Width: 33.0mm (1.30 in) Height: 13.0mm (0.50 in) Weight: 62.0 g (2.20 oz)