Details
FINISH-CURE 20 min. epoxy is an excellent, low odor substitute for polyester resins. It can be used for applying fiberglass cloth to wood or by itself to give wood a surface ready for primer and paint. FINISH-CURE can be sanded the easiest of all our epoxies and is excellent for the sheeting of foam core wings. Allow 8 hours for full curing.
Features
For best results, FINISH-CURE should be heated to a temperature above 85 degrees F or applying light weight fiberglass, lay cloth on balsa first, then brush on FINISH-CURE. When fully saturated, go over the surface with a heat gun, and then squeegee off excess epoxy with a playing card from an old deck. Heat and remove excess several times for a lightweight finish. If room temperature is below 70 degrees F use a heat gun on the surface several times for the next 2 hours. When dry, lightly sand, then fill the surface with a low-weight spackling compound, scrapping off excess with a playing card. Sand to a smooth finish ready for primer. For heavy-weight fiberglass, apply the epoxy before and after laying down the cloth. FINISH-CURE is best mixed in a disposable cup.
Works Best On:
- Fiberglass
- White Foam
- Laminating
- Water-Resistant
Works Good On:
- Balsa Wood
- Hard Wood
Guaranteed Fresh! Our products don't sit in a warehouse for months, but rather days. We order on a weekly basis from Bob Smith Industries so you are getting some of the freshest cyanoacrylate possible!